Securesight VL1 Spezifikationen PDF herunterladen (Seite 24)

Page No. 23

©Securesight 2009 E&OE Issue 1.0

Whilst the USB standard allows for only limited length cables, it is

possible to buy a USB extension cable up to 5m long. The USB menu

option allows you to leave a USB lead permanently connected to your

VL1 as the unit will behave the same way each time you connect your

computer. If set to MSDC you can access your recordings without having

to recover the SD card. If set to PC Camera you can use the VL1 as a web

camera and record directly to your PC (Additional software required).

When connected to your PC, the VL1 draws its power from the PC.

Therefore, in the event of a power failure and assuming your PC still has

power (like a laptop or a computer with an uninterruptible power

supply) your VL1 will continue to operate in either mode.

When mains power is connected and your VL1 is operating as a PC

camera the floodlight on your VL1 will continue to operate

independently, turning on when movement is detected. In this mode,

the light level at which the floodlight comes on is determined by the LUX

setting.

Should power fail whilst your VL1 is connected to a PC, the unit will

continue to work as a PC camera or removable disc drive, but the

floodlight will stop operating.

NOTE: When you disconnect the VL1 from your PC, the VL1 will reset.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 56 57

Keine Kommentare

Securesight VL1 Spezifikationen Seite 24